How Do You Set Up and Use a Lost Mary BM6000?
A clear UK guide to setting up your Lost Mary BM6000, priming the pod, charging it and getting the smoothest vape from the very first puff.
The short answer
Click in the pod, prime it for a few minutes, then just inhale.
Power
1000mAh battery that recharges by USB-C.
Airflow
Remove the small air cover or it will not fire.
Lost Mary BM6000 setup and use guide
The Lost Mary BM6000 is a refillable pod kit rather than a throwaway bar, so a little setup unlocks a much better vape. Insert the pod, remove the air cover, prime the coil for a few minutes and then draw to vape, recharging by USB-C when the battery runs low. Once you know the routine it takes under five minutes.
This guide walks through the whole process in plain steps, from opening the box to your first proper puff. We also cover priming, airflow, charging and the little habits that keep the flavour clean and the coil healthy across the full tank.
The BM6000 replaced the old disposable format when single-use bars were banned in June 2025, so many vapers are meeting the refillable version for the first time. The good news is that it feels almost as simple as a disposable once it is set up, yet it lasts far longer and costs a lot less per puff.
What is in the box
Before setup it helps to lay out the parts. A typical BM6000 kit contains the main device, a prefilled 2ml pod, a sealed refill container of e-liquid and a short user guide, though a USB-C cable is often not included so you may need your own.
- The device: holds the 1000mAh battery and the small OLED screen.
- Prefilled pod: a 2ml pod ready to click into place.
- Refill container: extra e-liquid that feeds the pod for a longer life.
- User guide: quick reference for safety and charging.
Remove every protective film and the silicone stopper from the mouthpiece before you begin. These are easy to miss yet they stop the device drawing properly if left on.
Step by step setup
Setup is quick once you have the parts in front of you. Follow the order below and give the coil time to soak, because rushing the first puff is the fastest way to a harsh burnt taste.
Insert the pod
Push the pod firmly into the device until you feel and hear a clear click into place.
Remove the air cover
Take off the small air hole cover on the side, since leaving it on stops the device firing.
Prime the coil
Leave it to stand for at least five minutes so the coil soaks up the e-liquid fully.
Take your first draw
Remove the mouthpiece stopper and inhale gently. It is draw activated with no buttons.
If you can see the e-liquid through the pod, tilt the device for ten to twenty seconds and watch for tiny bubbles rising, which is a good sign the wick is saturated. A few gentle primer puffs with no power, meaning short pulls before the coil has fired much, also help draw liquid into the coil.
Key specifications at a glance
Knowing the numbers helps you plan charging and refills. The BM6000 runs a 1000mAh battery, holds a 2ml pod topped up from a larger refill and delivers around 6000 puffs at 20mg nic salt strength.
| Feature | Detail | What it means for you |
|---|---|---|
| Battery | 1000mAh, USB-C | Recharge in around an hour rather than binning the device |
| Pod capacity | 2ml prefilled pod | Meets UK tank rules and clicks in fast |
| Puff count | Up to 6000 puffs | Roughly the life of many disposables in one kit |
| Nicotine | 20mg nic salt | Smooth throat hit suited to switching from cigarettes |
| Screen | OLED display | Shows battery and e-liquid level at a glance |
Ready to grab a Lost Mary BM6000?
Browse the full Lost Mary range at Vape Chaos, from starter kits to your favourite refill flavours. You can also call the team for a quick recommendation.
If you are weighing up your options before you buy, the Vape Chaos Lost Mary collection lays out every current kit, colour and refill in one place so you can pick the setup that suits you and get started the same day.
Charging and battery care
Charging is simple but a few habits extend the life of the cell. Plug a USB-C cable into the base, watch the OLED screen climb to full and unplug once it reads 100 percent rather than leaving it on charge overnight.
The screen shows an exact battery percentage while charging, which takes the guesswork out of it. Try to top up before the battery drops to zero, since keeping a lithium cell somewhere in the middle of its range is kinder over the long run. Charge on a hard surface away from anything flammable and use a good quality cable and plug.
How the BM6000 compares on daily use
Illustrative figures to show scale, your mileage will vary.
Getting the best from every puff
Small habits make a big difference to flavour and coil life. Vape in gentle, steady draws, top up the pod before it runs dry and give a fresh refill a minute or two to settle so the wick never runs hot.
Store the device upright when you can, keep it out of direct heat and wipe the contacts if the draw feels weak. If the flavour starts to fade or turns slightly harsh, that is usually the sign the coil in the pod is nearing the end of its life and a fresh pod will bring the taste right back. Treat it gently and a single BM6000 kit will happily see you through many refills.
Once your device is set up, the wider Lost Mary Guides hub is the place to go next, since it gathers every how-to in one library so you can move straight from setup to the topic you need.
From here it is worth learning the day to day tasks that keep the kit running. Our refill and pod change guide shows how to top up without spills, the charging guide covers timings and battery care in more depth and the troubleshooting guide helps if the device ever refuses to fire.
The bottom line: setting up a Lost Mary BM6000 means clicking in the pod, removing the air cover, priming the coil for about five minutes and then drawing to vape. Recharge by USB-C, watch the OLED screen for battery and liquid level and refill the pod before it runs dry. Do that and the kit delivers around 6000 puffs of smooth 20mg nic salt for a fraction of the cost of the old disposables.
Switching from disposables?
The Vape Chaos team can match you to the right Lost Mary kit and flavour so your move to a refillable pod is smooth and simple.
Frequently asked questions
How do you set up a Lost Mary BM6000?
Push the prefilled pod into the device until it clicks, remove the small air cover from the side so the device can fire and take off the silicone stopper from the mouthpiece. Let it stand for at least five minutes so the coil soaks up the e-liquid, then simply inhale to vape. It is draw activated so there are no buttons to press.
Why is my new BM6000 not firing?
The most common reason is the air hole cover still being in place, since the device will not draw with it on. Remove that cover and the mouthpiece stopper, check the pod is clicked fully home and make sure the battery has some charge. If it still does nothing, wipe the contacts and try a short charge on the USB-C port.
How long should you prime a Lost Mary BM6000?
Allow at least five minutes after inserting the pod so the coil fully saturates before your first puff. Skipping this step can scorch the wick and leave a burnt taste. Tilting the device for ten to twenty seconds to see bubbles rise, plus a couple of gentle pulls with no power, helps draw liquid into the coil faster.
How do you charge a Lost Mary BM6000?
Connect a USB-C cable to the port on the base of the device. The OLED screen shows the exact battery percentage as it climbs, so unplug it once it reads 100 percent rather than leaving it charging overnight. A full charge usually takes around an hour with a decent cable and plug.
Is the Lost Mary BM6000 refillable?
Yes. Unlike the old single-use bars, the BM6000 is a refillable pod kit with a rechargeable battery. It comes with a prefilled 2ml pod plus a larger refill container of e-liquid, so you top the pod up rather than binning the whole device. That makes it cheaper per puff and much less wasteful than a disposable.
