How Do You Refill and Change Lost Mary BM6000 Pods?

Lost Mary BM6000 refill and pod change guide

The BM6000 is refillable, so once the prefilled pod runs low you top it up rather than bin the device. Slot a Maryliq refill container onto the pod, let it click and feed the e-liquid in, then prime for a minute or two before you vape again. Change the whole pod only when the flavour dulls.

This guide covers the full routine, from spotting an empty pod to topping it up cleanly and knowing the moment a fresh pod is due. Done properly it takes under a minute and keeps every puff tasting the way it should.

Because the BM6000 pairs a small 2ml pod with a larger refill container, one pod can be topped up several times before the coil inside it wears out. That is what makes the kit last far longer than a single-use bar while costing much less per puff.

Refill or pod change: which do you need

It helps to know the difference before you start. A refill means adding more e-liquid to the same pod, while a pod change means fitting a brand new pod with a fresh coil. Most of the time you only need a quick refill.

• Refill: the liquid is low but the flavour is still clean and full.
• Pod change: the taste has faded or turned slightly harsh after several refills.
• Rule of thumb: expect a good few refills from each pod before the coil tires.
• Same e-liquid: the BM6000 is designed around Maryliq 20mg nic salt refills.

How to refill the pod step by step

Refilling uses a neat click-fill system so there is very little mess. Take the cap off the Maryliq refill, press it onto the pod until it clicks and squeeze gently so the liquid flows in, then lift it away and let the pod settle.

Avoid overfilling, since a pod that is brimful can gurgle or leak into the airway. Leaving a small gap at the top gives the coil room to breathe and keeps the draw smooth. It also helps to refill before the pod runs bone dry, because a coil that has fired with no liquid left can pick up a burnt edge that a single refill will not always shift.

Work over a surface you can wipe, keep a tissue nearby and go slowly the first few times. Once you have done it once or twice the whole routine becomes second nature and takes only a few seconds between sessions.

Refilling cleanly without spills

A tidy refill keeps the device reliable and the flavour pure. Hold the device upright, press the refill on squarely rather than at an angle and squeeze in slow pulses so you can watch the level rise instead of flooding the pod.

• Go slow: short gentle squeezes give you control over the fill.
• Stay square: a straight connection stops liquid escaping round the seal.
• Wipe the port: clear any stray drops before you vape to protect the contacts.
• Rest a moment: a minute of soak time stops that first puff tasting thin.

If your pod is genuinely spent rather than just low, it is worth browsing the Lost Mary collection for replacement pods and refill flavours so you always have a spare to hand and never miss a session.

When to change the pod

A refill fixes low liquid but not a tired coil. Once the flavour fades, the vapour thins or a faint burnt note creeps in after several refills, it is time to fit a fresh pod rather than keep topping up the old one.

Keeping a spare pod in a drawer is a small habit that saves a lot of frustration, since a coil rarely picks the most convenient moment to fade. With a fresh pod ready you can swap in seconds and carry straight on with your favourite flavour.

Before you go further, the Lost Mary Guides hub gathers every BM6000 how-to in one place, so you can move from refilling straight to whatever task comes next.

It pairs naturally with a few sibling guides. Our setup and use guide covers first-time priming, the pods and refills explained guide breaks down which pods fit and the Maryliq nic salt guide explains the e-liquid you are filling with.

Frequently asked questions